Website no longer active. Please use our new website Tegiwa.com
Details
*This is the weld-on steel tab only, does not come with the OEM reverse selector! Photos show it installed for reference.
This laser cut steel tab simplifies the task of installing an Input Shaft Speed Sensor in your ’98-’01 Honda CR-V SBXM transmission so that you can compare engine RPM to input shaft RPM to monitor clutch slip. We use this tab with a M DHALL 437 V2 sensor, sold separately.
Installation:
Tack weld one of the nuts that comes with the sensor to the tab on the side closest to the input shaft.
Mark and then weld the mounting tab to your reverse selector in a position that clears the full range of motion of the arm and allows you to place the hall sensor so that it reads off the 1st gear teeth.
Thread the other nut that comes with the hall sensor on, then thread in the sensor and adjust angle and sensor air gap as needed. Tighten the locknut.
Notch the transmission housing to allow the sensor wiring to pass through and seal with Hondabond when closing the transmission.
See photos for reference.
This laser cut steel tab simplifies the task of installing an Input Shaft Speed Sensor in your ’98-’01 Honda CR-V SBXM transmission so that you can compare engine RPM to input shaft RPM to monitor clutch slip. We use this tab with a M DHALL 437 V2 sensor, sold separately.
Installation:
Tack weld one of the nuts that comes with the sensor to the tab on the side closest to the input shaft.
Mark and then weld the mounting tab to your reverse selector in a position that clears the full range of motion of the arm and allows you to place the hall sensor so that it reads off the 1st gear teeth.
Thread the other nut that comes with the hall sensor on, then thread in the sensor and adjust angle and sensor air gap as needed. Tighten the locknut.
Notch the transmission housing to allow the sensor wiring to pass through and seal with Hondabond when closing the transmission.
See photos for reference.
More Info
| Manufacturer | Speed Factory |
|---|---|
| Fitment | No |
| Colour | N/A |
| Note | No |
- Be the first to review this product
You may also be interested in
SPEEDFACTORY RACING F20/22C THERMAL INTAKE MANIFOLD GASKET
£42.41 Excl. Tax £50.89 Incl. Tax
SPEEDFACTORY RACING BATTERY LOCATION FUEL CELL - EG/EK/DC Left Hand Drive
£488.27 Excl. Tax £585.92 Incl. Tax
SpeedFactory Turbo Manifold Bottom Mount Style Honda K Series 06-11 Civic Si w/ 44-46mm V-Band WG
£1,042.09 Excl. Tax £1,250.51 Incl. Tax
SpeedFactory Titanium Exhaust or Intake Manifold Stud Kit w/ 6pt Nut - M8x1.25x45mm - 10pcs - RAW
£100.12 Excl. Tax £120.14 Incl. Tax
© Tegiwa Imports Ltd | Registered in England Number 5798174
Finance provided by PayPal Credit. Terms and conditions apply. Credit subject to status, UK residents only, Tegiwa Imports LTD acts as a broker and offers finance from a restricted range of finance providers. PayPal Credit is a trading name of PayPal UK Ltd, Whittaker House, Whittaker Avenue, Richmond-Upon-Thames, Surrey, United Kingdom, TW9 1EH.
Finance provided by PayPal Credit. Terms and conditions apply. Credit subject to status, UK residents only, Tegiwa Imports LTD acts as a broker and offers finance from a restricted range of finance providers. PayPal Credit is a trading name of PayPal UK Ltd, Whittaker House, Whittaker Avenue, Richmond-Upon-Thames, Surrey, United Kingdom, TW9 1EH.